IMET KS450
larger imageMove mouse over the image to magnify
logo_imet.gif
www.imetsaws.com

In compliance with CEE Safety Standards and Electromagnetic Compatibility Norms (EMC).
Steel sawframe with tubular section; worktable supported by preloaded central bearing.
Automatic stops at the positions 45° left, 45° right and 0°.
Adjustable taper rollers located on the rocking pin.
360mm pulleys, Long Life reducer.
Blade-driving guides with hard metal pads and driving bearings.
 
  • Electric equipment complying with E.C. Norms EN60204-1, EN-55011, EN-50082-2.
  • Low tension 24V, general switch which can be locked, minimum tension coil, thermo-magnetic overloads motor protection, emergency button
  • Cutting cycle: fast approach of the sawframe to the cut-start point, then the machine adopts the cutting speed until reaching the cut-end point, which is checked by a microswitch; as a final step, the sawframe goes back to the cut-start position
  • Mechanical blade tensioning, microswitch for checking the tension, instant stop in case the blade breaks or is not tensioned
  • Supporting roller of 500mm width, both on the loading and unloading side
  • LED located on the control panel for checking: blade tension, blade protection opened, motor thermic overload
  • Hydraulic front vice free to slide transversally on the worktable, supported by recirculating-ball guides
  • Quick approach to the workpiece
  • Blade-cleaning device by means of a motorized brush
  • Floor stand equipped with removable chips collector and apt to be moved with forklift
  • Hydraulic unit with oil
  • Tank and electric pump for coolant
  • Bi-metal band
  • Wrenches and manual of instructions, maintenance and spare parts

 
00991

IMET KS450

Hydraulically driven semiautomatic bandsaw, suited for cutting metal profiles and solids from 60° left to 60° right.
Enquire

You might also be interested in ...

 
EX STOCK
 
LOCATION
108G Station Road
(Corner of Marjorie Jayne Cres)
Otahuhu
Auckland 1062
New Zealand
VIEW MAP