www.imetsaws.com

Hydraulically driven semiautomatic bandsaw, suited for cutting metal profiles and solids from 60° left to 60° right.
In compliance with CEE Safety Standards and Electromagnetic Compatibility Norms (EMC).
Steel sawframe with tubular section; worktable supported by preloaded central bearing.
Automatic stops at the positions 45° left, 45° right and 0°.
Adjustable taper rollers located on the rocking pin.
360mm pulleys, Long Life reducer.
Blade-driving guides with hard metal pads and driving bearings.

• Electric equipment complying with E.C. Norms EN60204-1, EN-55011, EN-50082-2.
• Low tension 24V, general switch which can be locked, minimum tension coil, thermo-magnetic overloads motor protection, emergency button
• Cutting cycle: fast approach of the sawframe to the cut-start point, then the machine adopts the cutting speed until reaching the cut-end point, which is checked by a microswitch; as a final step, the sawframe goes back to the cut-start position
• Mechanical blade tensioning, microswitch for checking the tension, instant stop in case the blade breaks or is not tensioned
• Supporting roller of 500mm width, both on the loading and unloading side
• LED located on the control panel for checking: blade tension, blade protection opened, motor thermic overload
• Hydraulic front vice free to slide transversally on the worktable, supported by recirculating-ball guides
• Quick approach to the workpiece
• Blade-cleaning device by means of a motorized brush
• Floor stand equipped with removable chips collector and apt to be moved with forklift
• Hydraulic unit with oil
• Tank and electric pump for coolant
• Bi-metal band
• Wrenches and manual of instructions, maintenance and spare parts

	350 330 450x320 330 320 320x300 160 150 150x270 330 320 320x300 210 200 180x270
	H= 27 S= 0.9 Lungh.= 3930
	3~ 1 2,2
	18÷100 460 980